Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 7, 2015 18:55:14 GMT
OK got a small boat trailer in order to get the pin in on the spindles I had to cut the grove in depper on the nuts. Ok I'm thinking of cutting the spindles off and welding New ones on that will work with my hubs.
The way it is I have no springs I could put new axle, spindles, springs and all on but it has always worked good the way it is. Thinking why change if it is working.
Thoughts?
Rockpile
|
|
|
Post by hermitjohn on Sept 7, 2015 19:05:54 GMT
Dont fix what aint broken...
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 7, 2015 23:55:54 GMT
Dont fix what aint broken... Well wanting to fix it where I can greese the bearings easier. Rockpile
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 8, 2015 0:11:21 GMT
Honestly, for what it would cost to buy all of the parts listed, you could buy a used trailer already built that way, then sell your old one and pocket a few bucks.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 8, 2015 3:36:26 GMT
Ok thinking just getting a Cover with Grease Sert so I can Grease the Bearings easier, call it good until it falls apart.
Rockpile
|
|
|
Post by copperkid3 on Sept 8, 2015 12:31:08 GMT
See how easy it is to make a decision when you come here for 'suggestions'?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 9, 2015 0:23:11 GMT
See how easy it is to make a decision when you come here for 'suggestions'? You know you go to do things and get in a hurry can cost you and not really be what you want. Step back, know what you want, think it over usually have what you want far cheaper.
Rockpile
|
|